Call Now Skip to main content

Roofing Services in Austin & Central Texas

Every site visit begins with a thorough roof evaluation to diagnose issues such as leaks, damaged shingles, flashing failures, and localized wear and tear. We provide professional roof repair services in Austin and Central Texas for maintenance work, real estate transactions, storm damage, and partial roof repairs. Our focus is on identifying the true source of the issue and performing targeted repairs that restore roof performance without unnecessary replacement.

Finished architectural shingle roof on a brick home, drone overview
Architectural shingle, Central Texas

Asphalt shingle

Shingle Roof Replacement

When a roof has reached the end of its life or taken real storm damage, we replace it down to the deck and build it back in the order the manufacturer specifies:

  • Tear-off to bare decking; every sheet checked for rot and soft spots, problems photographed and shown to you before we go on
  • Damaged decking replaced; ice-and-water shield in valleys and around penetrations; synthetic underlayment over the whole roof
  • Starter, drip edge, step flashing at walls, pipe boots, field shingles, hip and ridge caps
  • Magnetic sweep of the yard, gutters cleared, and a walk-through with you

We photograph the whole job, tear-off to last nail, and share it with you.

Gray standing-seam metal roof on a modern white home, drone overview
Standing seam, Central Texas

Standing seam metal

Standing Seam Metal Roofing

The premium option for a Texas roof. Standing seam handles hail, heat and high wind better than asphalt and typically lasts decades longer. We install it in a range of profiles and colors and document every transition — metal to brick, metal to stone, valleys, drip edges — with photos before it’s sealed up. Custom soffit and fascia to match when you want it.

It costs more up front, and we are upfront about that. Before any panel goes on we check the deck plane; if it isn’t true we correct the framing first, because metal shows every dip beneath it.

Finished PBR / R-panel metal roof in Galvalume, drone overview
PBR panel, Galvalume

PBR / R-panel metal

PBR & R-Panel Metal Roofing

The exposed-fastener metal roof: wide panels with a rib every twelve inches, screwed through the face with gasketed fasteners and sealed at the side laps. It costs less than standing seam, goes on faster, and you see it on shops, barns and plenty of houses across Central Texas.

The trade-off is the fasteners. Every screw has a rubber washer that ages in the sun, so a PBR roof wants a fastener check every several years. We install PBR, and we repair and re-screw existing PBR roofs.

Panels going down over the framingRake trim over a wood nailerHip cap fitted over panel endsFinished ridge line
Clay S-tile roof on a stucco home, finished
Clay tile, S-profile

Clay & concrete tile

Clay & Concrete Tile Roofing

We do all tile, clay and concrete. How a tile roof gets installed depends on the product and the system it sits on, so we don’t treat every tile roof the same way. Our owner trained and certified through the Tile Roofing Institute.

  • Isolated repairs — a flashing, a wall junction, a cracked run of tile, with the original tile put back
  • Spot or slope replacement where one area has failed underlayment and the rest is sound
  • Full detach and reset — tile lifted and stacked, new waterproofing across the roof, original tile reinstalled
  • A system from scratch: underlayment, battens or counter-battens, flashings and new tile

Tile roofs rarely fail at the tile. They fail at the flashings and the underlayment, which is where our attention goes first.

FLIR thermal scan showing a cold spot at a ceiling-wall junction
Thermal scan at a ceiling-wall junction

Inspections

Roof Inspections

An inspection with us starts with why you called, then goes inside if there’s a sign, walks every elevation, and then the roof. We use a thermal camera and moisture meter to find water you can’t see, and a drone for overviews and roofs that shouldn’t be walked. Hail is measured with a gauge, not eyeballed.

You get a written report with photos, organized by priority. If the roof is fine, the report says the roof is fine. There’s no charge.

Storm damage & insurance

Insurance Claim Support

We don’t recommend filing a claim. That decision belongs to the policyholder, not the contractor. What we do is make sure you decide with accurate information and a complete record in hand.

Documentation

Every area of concern photographed: close-ups, wide shots, drone aerials, thermal imaging where it applies. Your adjuster gets a full package, not a blurry phone photo.

Scope

Clear, itemized scope so there’s no ambiguity about what was damaged and what it takes to repair or replace it. We explain; we don’t negotiate your claim.

Education

What to expect from your carrier, what your deductible really means, and what to ask. If your roof doesn’t need replacing, we’ll say so, even when it costs us the job.

Leak location chalk-marked on a shingle roof during a repair
A leak, found and marked

Repairs

Emergency & Temporary Repairs

When water is coming in, the first job is to stop it. We tarp or seal the vulnerable area to stabilize the roof and protect the house until a permanent repair or replacement can be done right.

Storm damage doesn’t wait for business hours. If your roof is actively leaking or has been hit by weather, call and we’ll get it stabilized as quickly as we can, then find the actual source rather than sealing over it.

Pricing

What Drives the Cost of a Roof in Austin?

Two houses with the same square footage can land far apart. Here is what moves the number, by roof type.

Asphalt shingle

Roof size and pitch, how many facets and penetrations, the shingle grade you choose (standard architectural vs. Class 4 impact-resistant), and what the deck looks like once the old roof is off.

Metal

Standing seam costs meaningfully more than shingles up front, and roofs with lots of hips, valleys and transitions add to it. In return it tends to last far longer. PBR sits between the two.

Repair vs. replacement

Not every roof problem needs a new roof. Flashing fixes, small leak repairs and isolated shingle work are a fraction of a re-roof, and we’ll tell you which one your roof actually needs.

We don’t publish price ranges because they go stale fast and never fit your roof. What you get instead is a free inspection and a written, line-by-line estimate you can compare against anyone else’s. Read what actually drives roof pricing →

Frequently Asked Questions

How long does a full roof replacement take?

Most residential roof replacements in Austin take 1 to 3 days depending on the size of the home and complexity of the roof. We give you a realistic timeline before we start, not an optimistic one.

Do I need a full replacement or just a repair?

It depends on the age of your roof, the extent of the damage, and the condition of the decking underneath. If a repair can extend your roof life by 5 or more years, we will recommend that instead. We do not push replacements when they are not necessary.

Will my homeowner insurance cover it?

We do not recommend filing an insurance claim on your behalf. That decision belongs to you. What we do is document everything thoroughly with photos, thermal imaging, and detailed scope reports so you have what you need if you choose to file. We help you understand the process, not pressure you into it.

What materials do you use?

We use quality materials from manufacturers like GAF, Owens Corning, and CertainTeed for asphalt shingles. For metal roofs, we work with standing seam panels rated for Texas weather. We will walk you through the options and explain the real differences — not just sell you whatever has the highest margin.

Do you handle permits?

Yes. We pull all required permits through the City of Austin and ensure every project meets local building codes. You should never have to worry about permit compliance.

What makes Escalante different from other roofers?

We use FLIR thermal imaging to find leaks other roofers miss. We photograph every stage of the job and share it with you. We publish our pricing on our website. And we will tell you when your roof does not need to be replaced — even if it costs us the job. Most roofers will not do any of those things.

Ready to Talk About Your Roof?

No sales pitch. No pressure. Just an honest conversation about what your roof needs.

Call us at 512-887-4250 or fill out the form on our contact page and we will get back to you.

We would rather earn your trust with honesty than win your business with a gimmick.