Call Now Skip to main content
Our Process

How we replace a roof — every time.

The same sequence on every job, because the parts that protect your home are the parts you never see once it's done. Here's exactly what we do, and why each step matters.

1

We protect your property first

Before a single shingle comes off, we set up our catch-all system — tarps and protection over your landscaping, siding, windows, AC units, and anything in the fall zone.

Why it matters — tear-off is messy. Protecting your home first means the only thing that changes is the new roof over your head.
Catch-all tarp system set up before tear-off
Our catch-all system up before tear-off begins
2

Full tear-off, down to the deck

We strip the old roof all the way to the wood decking. We don't shingle over the old roof to save a day of labor.

Why it matters — roofing over an old roof hides problems. Taking it to the deck is the only way to see — and fix — what's underneath.
Roof stripped to the bare wood decking
Stripped down to the bare wood decking
3

We inspect and repair the decking

With the deck exposed, we check every sheet for rot, soft spots, and storm damage, and replace what's no longer sound. If we find it, we document it and show you before we cover it up.

Why it matters — a new roof is only as good as the wood it's nailed to. This is where hidden damage shows up — and where you deserve to see the proof.
New decking replacing wood that was no longer sound
New decking where the old wood was no longer sound
4

We waterproof and seal the weak points

We install drip edge along the edges, a self-sealing ice-and-water membrane in the valleys and around every penetration — pipes, vents, chimneys — and a synthetic underlayment across the whole deck.

Why it matters — valleys and penetrations are where roofs leak. Sealing them properly is the difference between a roof that looks finished and one that actually keeps water out.
Ice-and-water leak barrier sealed into the valley
Leak barrier sealed into the valley
5

Starter strip and new flashing

We run a sealed starter course along every edge and install new flashing where the roof meets walls, chimneys, and valleys. We don't reuse old, rusted flashing.

Why it matters — the edges and transitions take the most wind and water. New starter and flashing lock them down.
New metal flashing where the roof meets the chimney
New flashing where the roof meets the chimney
6

We install the shingles the right way

Your shingles go on to the manufacturer's specification — correct nail placement and pattern, properly staggered courses.

Why it matters — most shingle failures aren't the shingle — they're how it was nailed. Doing this by the book is what makes the warranty hold and the roof last.
Shingles installed to spec, course by course
Shingles installed to spec, course by course
7

Ventilation, ridge cap, and a spotless cleanup

We finish the ridge with proper attic ventilation and ridge-cap shingles, then clean up completely — including a magnetic sweep of your yard and driveway for stray nails.

Why it matters — good ventilation protects the roof from the inside out, and the magnet sweep protects your family, pets, and tires.
The finished roof from the ridge
The finished roof
And then we walk it with you

We'd rather show you than tell you.

When the roof is done, we walk it with you and share the documentation from the job — not because a contract requires it, but because it's how we've always worked.

You should never have to wonder whether you got what you paid for.

Ready when you are

Every roof follows this process.

Let's start with an honest inspection — no pressure, clear answers, and a report of exactly what we find.